![lap steel guitar plans lap steel guitar plans](https://i.ytimg.com/vi/3w0_yGRqXqA/maxresdefault.jpg)
Mark your fret guides: Measure out the frets by starting at the 26” nut location and making pencil marks for each fret location. Use a 3/32 drill bit to drill six holes for the strings to feed through the body. Use the same dado technique as above with the headstock.Ġ7. Cut out the pickup cavity: Notch out the wood between the 4 ½” and 6” line. Turn the 2×4 back over and the following marks on the board, starting from the butt end and going up toward the headstock: a) 1.5” (this will be our through-body string feed) b) 3” (bridge location) c) 4.5” (pickup cavity) d) 6” (pickup cavity) e) 26” (nut location)Ġ6. Use a 5/8” drill bit to drill the tuner holes.Ġ5. I went in about 5/8” in on each side and spaced the tuners roughly an inch apart. Drill tuner holes: Mark your tuner holes on the underside of the headstock. Optional: I smoothed out the underside of the headstock on my belt sander. (Still unsure? Here’s a link to a quick tutorial.)Ġ3. You can also do the same thing by running the saw in multiple passes over the shaded area and then using a chisel to remove any extra wood chips. Cut away the bottom portion in the headstock area (shaded are in the picture). Mark a horizontal line 5/8” from the top (as pictured). Cut out the headstock: Turn the 2×4 on its side and mark a vertical line 4” from the left end. Cut a standard pine 2×4 into a 32” length.Ġ2.
#Lap steel guitar plans how to
(I built it so that I could learn how to play it). Here’s a quick video (below).Īs you can tell, I’m still learning how to play this properly. It’s set up with a standard 23-inch scale, just like the store bought-lap steels! The whole thing feels great on your lap and looks absurdly cool. I even used a pre-wired acoustic sound hole pickup, so there was no wiring needed.Īnybody can build this lap steel guitar! The lap steel plays great, too. This lap steel was made from an extra 2×4 I had in my shed, with just a few saw cuts to the wood. This is one of the easiest homemade guitars I’ve ever built, and it took me only an hour to make.
![lap steel guitar plans lap steel guitar plans](https://www.awesomeinventions.com/wp-content/uploads/2015/12/lap-skate-guitar-close.jpg)
The DIY Musician: How to Build a 2×4 Lap Steel Guitar